Magnetic Build Surface
Buy this Copymaster3D Magnetic Build surface as a spare or replacement for your 3D printer.
Cut to 310x310mm this will fit a wide variety of 3D Printers Including:
CR-10, CR-10S, Anet E10, Anet ET5. Artillery Sidewinder X1 and X2. You will get the print surface (Sheet A) and the bottom magnetic layer (Sheet B).
It is easily installed on your 3D Printer following these easy steps:
- Remove the backing on Sheet B. Stick this directly to your 3D Printers Heated Bed. Place Sheet A on top. Accurate bed levelling and offset adjustment is important, so you don’t damage your build surface.
- Do not use any tape, adhesive sprays, or liquids. Clean your bed regularly by using a mild soapy water solution made with warm water.